Table of Contents
Advertisement
Assembly and installation guidelines
Assembly SPEED-Bus
Installation CPU without
Standard-Bus-Modules
Installation CPU with
Standard-Bus-Modules
Installation Standard-Bus-
Modules
20
4.
To connect the SPEED-Bus modules, plug it between the triangular positioning
helps to a slot marked with "SLOT ..." and pull it down.
5.
Only the "SLOT1 DCDC" allows you to plug-in either a SPEED-Bus module or an
additional power supply.
6.
Fix the CPU by screwing.
1.
To deploy the SPEED7-CPU exclusively at the SPEED-Bus, plug it between the tri-
angular positioning helps to the slot marked with "CPU SPEED7" and pull it down.
2.
Fix the CPU by screwing.
1.
If also standard modules shall be plugged, take a bus coupler and click it at the
CPU from behind like shown in the picture. Plug the CPU between the triangular
positioning helps to the slot marked with "CPU SPEED7" and pull it down.
2.
Fix the CPU by screwing.
Repeat this procedure with the peripheral modules, by clicking a backplane bus
coupler, stick the module right from the modules you've already fixed, click it down-
wards and connect it with the backplane bus coupler of the last module and bolt it.
VIPA System 300S
HB140 | CPU | 317-4PN23 | en | 18-01
+
Advertisement
Table of Contents
