Table of Contents
Advertisement
Hybrid Spot
Quick start instructions
Figure 1.1
Air Pressure
Hybrid Spot Control Panel
Air Pressure
Regulator
All Info Copyright © Pro Spot International Inc.
1. Turn the power switch on the front panel ON (Fig 1.1).
2. Connect Air to the air inlet located on the back panel.
3. Turn the "WELD SWITCH" to the weld position.
4. Turn on the desired amount of battery power by using the battery selector
switches (1-4). For two-sided welding use 3 to 4 batteries in the ON position.
For single-sided welding use one battery. Adjust weld time to 260-300 for two-sided.
120 for single-sided.
5. Place the welding gun at the weld area and press the lower trigger button to weld.
The upper weld button is for spreading the electrodes open for better access.
The welder is now ready to operate. Make sure air pressure is set at 90 PSI.
NOTE: When the welder is not being used, turn the power switch off. Leave
power cord plugged in to allow unit to charge.
System Display.
Shows battery voltage and charge current.
80
Batt1
15.30V
Batt2
15.30V
Batt3
15.30V
Batt4
15.30V
ELECTRODE
PRESSURE
CHARGING
DC AMPS
BAT 1
Air Cooling
Switch
1.5A
1.5A
1.5A
SERVICE
1.5A
PUSH TO
TEST BATTERY
ON
BAT 1
BAT 2
CHARGING
CHARGING
DC AMPS
DC AMPS
BAT 2
BAT 3
HYBRID SPOT
Weld
Switch
ON
POWER
OFF
READY
WELD
BAT 1
TEST
260
BAT 2
190
300
TEST
BAT 3
TEST
120
350
BAT 4
TEST
WELD
TIME
ON
ON
ON
BAT 3
BAT 4
CHARGING
DC AMPS
BAT 4
PHS-100
Power
Switch
Ready
Weld
Time Knob
Battery
Selector
Switch
Charge
Indicator
Displays
4
Page 3
Advertisement
Table of Contents
