Hydrostatic Steering Valve Assy Reassembly - Toyota 8FGU15 Repair Manual

2 STEERING
Reassembly Procedure
The reassembly procedure is the reverse of the disassembly procedure.
Point Operations
a
c
a
Point 1 Disassembly:
Make a match mark across the end cover, outer gear,
a
and valve body.
Reassembly:
Follow the steps below for reassembly.
a: Match mark
1. Align the match marks made at the time of disas-
2. Two types of set bolts are used.
A
Point 2 Reassembly:
Install the drive shaft and inner gear in the illustrated
relative positions.
b
The spool pin shall pass the slit in the drive shaft.
a: Drive shaft match mark
b: Pin
c: Inner gear match mark
Reassembly:
Install the outer gear with its side having the ∇ mark
facing the end cover side.
a: Mark
sembly.
• Set bolt with '10' mark on the head
• Set bolt without any mark on the head
Use a rod-tip bolt with no mark on its head at pos-
ition A in the illustration at left.
2-13
2