7 DISPLAY
7.2.6.7 MATCHING EMRV "EMRV"
Perform the setting for current level of electromagnetic relief valve.
It is set appropriately for each electromagnetic relief valve before shipping. So if replacing OCV or SAS/OPS
controller, perform the resetting by the value written or attached at OCV.
CAUTION
In case of "without" multi-function display spec, perform the matching by using diagnostic program
(SST).
Operating Procedure
▪ "LEVER3" Screen
If matching is performed (press switch (1)), "OK" is indic-
ated on the display.
Switch (1): Pressing this for more than 2 seconds will per-
form matching.
Switch (4): To "LEVER4" screen
NOTICE:
▪ "LEVER3" screen will be displayed according to the
number of ways being set.
▪ "LEVER4" Screen
If matching is performed (press switch (1)), "OK" is indic-
ated on the display.
Switch (1): Pressing this for more than 2 seconds will per-
form matching.
Switch (4): Returning to "MATCHING MENU" screen
NOTICE:
▪ "LEVER4" screen will be displayed according to the
number of ways being set.
Step 1
Display the "MATCHING MENU" screen.
7-139
7