Before Starting Matching; Mini Lever; Emrv; Standard Vehicle Condition - Toyota 8FGU15 Repair Manual

7-132

2. MINI LEVER

No. Indication
1 LEVER1
2 LEVER2
3 LEVER3
4 LEVER4

3. EMRV

No. Indication
1 C01
2 C02
Prerequisite content for implementation
*1: SAS/OPS controller replacement
*9: When replacing lift lever angle sensor
*10: When replacing tilt lever angle sensor
*11: When replacing attachment (1) lever angle sensor
*12: When replacing attachment (2) lever angle sensor
*13: When removing/installing or replacing oil control valve

7.2.6.3 BEFORE STARTING MATCHING

Set the vehicle to "Standard vehicle condition" before starting matching.
"Standard vehicle condition" means that the vehicle satisfies the conditions described below.

Standard vehicle condition

NOTICE:
▪ Items 1 to 4 below show the standard vehicle condition for SAS matching.
▪ Before carrying out matching for mini lever/joystick vehicles, move the armrest to the driving po-
sition and check the neutral state of the levers.
▪ In case of a detachable attachment, keep the attachment installed on the vehicle.
Level surface
Description
Lift lever angle sensor output value in the lift lever neut-
ral position is stored in the controller.
Tilt lever angle sensor output value in the tilt lever neut-
ral condition is stored in the controller.
Attachment (1) lever angle sensor output value in the at-
tachment (1) lever neutral position is stored in the con-
troller.
Attachment (2) lever angle sensor output value in the at-
tachment (2) lever neutral position is stored in the con-
troller.
Description
Electromagnetic relief valve solenoid current L level
Electromagnetic relief valve solenoid current H level
1. Tire pressure check
2. Surface levelness check
Adjust the tire pressure to the specified level. Match-
ing will be inaccurate if the pressure is low, or if there
are air pressure fluctuations between front and rear
as well as left and right.
If matching is conducted on an inclined or rough floor
surface, errors in standard vehicle condition will oc-
cur, so perform matching on a flat, level surface (in-
clination: within 0.5°).
7 DISPLAY
Prerequisite for im-
plementation
*1, *9
*1, *10
*1, *11
*1, *12
Prerequisite for im-
plementation
*1, *13
*1, *13