Electrolux IC4 4819 FFS Service Manual page 243

Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Replacement of the KM3 contactor:
If the contact of the contactor do not stick when the contact coil is supplied manually, this means
that the contactor is faulty.
Remove / Assembly:
1. Remove the left side frame of the machine.
2. Disconnect the wire of the faulty contactor.
3. Remove the contactor and replace it by a new one.
4. Connect the wire on the new contactor.
5. Switch on the machine and check the operation of the fan.
6. Put back the frame back.
Replacement of the M3 motor:
Remove / Assembly:
1. Remove the rear housing of the machine.
2. Disconnect the hose of the spiral.
3. Disconnect the wire of the faulty motor.
4. Remove the motor, support and spiral assembly.
5. Remove the spiral and the turbine of the support and the motor.
6. Remove the motor of the support and replace it by a new one.
7. Put the turbine and the spiral on the new motor and the support.
8. Put the motor, support and spiral assembly back on the machine.
9. Connect the wire on the new motor.
10. Put back the hose of the spiral.
11. Switch on the machine and check the operation of the feeding table vacuum.
12. Put back the frame.
04102011/GB
21-2012
Feeding: Vacuum system
(electricity, steam, water, gas, compressed air...).
28
5