Install Sd Card - Honeywell Thor VM1 Reference Manual

Install SD Card

Equipment Required - User Supplied:
Torquing tool capable of measuring inch pounds
l
#2 Philips screwdriver bit
l
SD card - The following commercially available SD cards are recommended:
l
Transcend® 2GB Industrial SD card (80X Speed) - TS2GSD80I
o
ATP 4GB Industrial Grade SDHC card - AF4GSDI
o
1. For convenience, the Thor VM1 can be removed from the Quick Mount Vehicle Dock, though it is not necessary.
2. Place the Thor VM1 in Suspend by pressing the Power button.
3. Place the Thor VM1 face down on a stable surface.
4. Using a Phillips screwdriver (not supplied) loosen the screws and then remove the tethered access panel with the SSD
and SD label. This panel is on the left hand side when the Thor VM1 is face down with the top away from the user.
5. Locate the SD card installation slot.
6. Slide the SD card into the slot. The label side (front) of the SD card faces toward the back of the Thor VM1.
7. Reattach the access panel, torquing the screws to 4-5 inch pounds.
8. If removed, reinstall the Thor VM1 in the Dock.
9. Resume the Thor VM1 from suspend.
10. When using Windows explorer to view My Device, the SD card is identified as Storage Card.
2-37