Bluetooth Beep And Led Indications; Bluetooth Printer Setup - Honeywell Thor VM1 Reference Manual

Bluetooth Beep and LED Indications

Beep Type from Bluetooth Device
Acknowledge label
Label rejected
Transmission error
Link successful
Link unsuccessful
LED on Bluetooth Device
Yellow LED blinks at 2 Hz
Off
Yellow LED blinks at 50 Hz
Yellow LED blinks at the same rate as the paging beep (1 Hz) Paging
Green LED blinks once a second
Upon startup, if the scanner sounds a long tone, this means the scanner has not passed its automatic Selftest and has entered
isolation mode. If the scanner is reset, the sequence is repeated. Contact your

Bluetooth Printer Setup

The Bluetooth managed device should be as close as possible, in direct line of sight, with the Thor VM1 during the pairing
process.
1. Open the LXEZ Pairing Panel.
2. Tap Discover. Locate the Bluetooth printer in the Discovery panel.
3. Tap and hold the stylus (or doubletap) on the Bluetooth printer ID until the right-mouse-click menu appears.
4. Select Pair as Printer to pair the Thor VM1 with the Bluetooth managed printer.
The devices are paired. The Bluetooth managed printer may respond with a series of beeps or LED flashes.
Please refer to the Bluetooth managed printer manufacturer's User Guide; it may be available on the manufacturer's web site.
Contact your representative
Note: If there is no beep or no LED flash from the Bluetooth managed printer, the Thor VM1 and the printer
are currently paired.
for Bluetooth product assistance.
Behavior
1 beep
2 beeps at low frequency
Beep will sound high-low-high-low
Beep will sound low-medium-high
Beep will sound high-low-high-low
Behavior
Linking in progress
Disconnected or unlinked
Bluetooth transmission in progress
Disabled indication
representative for assistance.
3-71