Rebooting The Thor Vm1; Warmboot; Restart; Clearing Persistent Storage / Reset To Default Settings - Honeywell Thor VM1 Reference Manual

Rebooting the Thor VM1

If a USB drive, such as a thumb drive is attached to the Thor VM1, the device attempts to boot from the USB drive:
If the USB drive contains a bootable sector, the Thor VM1 boots from the USB drive.
l
If the USB drive does not contain a bootable sector, the Thor VM1 does not boot. Remove the USB drive and
l
boot the Thor VM1 again.

Warmboot

A warmboot reboots the Thor VM1 without erasing any registry data. Configuration settings and data in RAM are preserved
during a warmboot. Network sessions are lost and any data in running applications that has not been previously saved may be
lost. CAB files already installed remain installed.
There are several warmboot methods available:
Using the Registry, select
l
immediately warmboots.
Using the Start menu, select Start > Run and type WARMBOOT in the text box. Press Enter. The Thor VM1
l
immediately warmboots. The WARMBOOT text command is not case-sensitive.
For the 64-key keypad, use the Ctrl + Alt + Del keypress sequence to reboot the Thor VM1. The keys may be pressed
l
in sequence; they do not need to be held down simultaneously.
For the 12-key keypad, use the 2nd + F5 + Shift keypress sequence to reboot the Thor VM1. The keys may be pressed
l
in sequence; they do not need to be held down simultaneously. This reboot sequence also works on the 64-key keypad.
If 2nd + F5 is remapped to another key, pressing 2nd + F5 generates the remapped key. However, if the next
keypress is Shift, the Thor VM1 reboots. The remapped keypress DOES NOT affect the 2nd + F5 + Shift reboot
key sequence.

Restart

A restart reboots the Thor VM1 without erasing any registry data. Configuration settings are preserved during a restart.
Network sessions are lost and any data in running applications that has not been previously saved may be lost. The contents
of RAM are erased and the operating system and CAB files are reloaded.
To initiate a restart:
Using the Registry, select
l
immediately restarts.
Using the Start menu, select Start > Run and type RESTART in the text box. Press Enter. The Thor VM1 immediately
l
restarts. The RESTART text command is not case-sensitive.

Clearing Persistent Storage / Reset to Default Settings

Use the Registry control panel Load Factory Defaults button to set the Thor VM1 registry back to factory defaults. No other
clearing is available or necessary.
Start > Settings > Control Panel > Registry
Start > Settings > Control Panel > Registry
and tap the Warmboot button. The Thor VM1
and tap the Restart button. The Thor VM1
3-3