Communicating With System Manager Cip 141 6.1. General; Recommended Pc Requirements - Emerson Lorain CIP 4890 AP6C55CB User Manual

6. Communicating with System
Manager CIP
6.1. General
The remote GUI of System Manager CIP can be accessed remotely in three
ways:
6.2.

Recommended PC requirements

Your PC must meet the following minimum requirements to allow you to
remotely connect to the System Manager CIP.
User Manual
Lorain Power System (AP6C55CA/CB)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
•
using a computer equipped with a web browser and connected locally
into the RJ45 Ethernet port through a cross-over Ethernet cable
(optional - A7000827),
•
using a computer equipped with a web browser and connected
remotely through a LAN or WAN network connection into the RJ45
Ethernet port (straight cable required), or
•
using a computer equipped with a web browser and connected
remotely through a dial-up network connection into the RS-232 port
via an external modem.
Note: If you do not have experience with computer communication,
before attempting to carry out the instructions contained in this Chapter,
contact your information system or network expert to make sure your PC is
connected to the System Manager CIP with the proper cables and that the
communication parameters have been properly configured.
•
Hardware:
Processor – Pentium 120 MHz or higher,
32 MB of RAM or better,
Network card, and
Network cable with switched connector.
•
Software:
Operating system - Windows 95 or later, and
Netscape Navigator 4.0 or later, or
Internet Explorer 4.0 version 4.72 or later.
141
UM6C55C (P7000597)
Standard 10.00 (March 2008)