Figure 3.15 – Connecting Details On The Controller Interface Card - Emerson Lorain CIP 4890 AP6C55CB User Manual

40 Specifications
Protection device configurations for the loads:
3.2.5.3. Controller interface card
The controller interface card is a printed circuit board mounted behind the
front panel of the Lorain CIP shelf. This board is equipped with three
terminal blocks and a connector used for wiring interface between the
controller and outside circuitry such as a battery temperature probe, an
external fuse alarm signal, and an external battery fuse alarm signal (–48 V dc
signals are required to activate the fuse and battery fuse alarms).
Figure 3.15 – Connecting details on the controller interface card
UM6C55C (P7000597)
Standard 10.00 (March 2008)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
•
up to six 1 A to 100 A single-pole circuit breakers or 1 A to 50 A fuses,
or
•
up to three 1 A to 100 A single-pole circuit breakers or 1 A to 50 A
fuses and one 10-position (SAN-O) fuse kit for fuses ranging from
0.180 A to 20 A or one 8-position (GMT) fuse kit for fuses ranging
from 0.180 A to 15 A, or
•
up to two 10-position (SAN-O) fuse kits for fuses ranging from
0.180 A to 20 A, or
•
up to two 8-position (GMT) fuse kits for fuses ranging from 0.180 A to
15 A.
Note: In Europe, ferrite beads may be required around signal wires and/or
cables (alarms, temperature probe, etc.) at the point of entry in the Lorain
CIP shelf, depending on the configuration, in order to meet European EMI
requirements.
Lorain Power System (AP6C55CA/CB)
User Manual