Emerson Lorain CIP 4890 AP6C55CB User Manual page 122

122 Configuring and operating the system
To enable the PPP, in the Communication Mode box, click on the button, and
select the modem type among the list in the Media Selection drop-list menu
(PSTN Modem or GSM Modem). Confirm the choice by clicking on the
TCP/IP Settings
Clicking on TCP/IP Settings in the submenu screen for PPP Settings will
display the following screen.
Screen 52
This screen is used to set the TCP/IP parameters for PPP interface. Enter the
applicable PPP interface IP address, Subnet mask and Gateway address, and
then confirm these settings by clicking on the
Settings box.
Clicking on the
to the TCP/IP factory default settings.
PSTN Modem Settings
If PSTN Modem was selected in the Media Selection drop-list menu of the
Communication Mode box in screen 57, click on PSTN Modem Settings in
the submenu screen for PPP Settings. The following screen will be displayed.
UM6C55C (P7000597)
Standard 10.00 (March 2008)
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
button.
button in the TCP/IP Factory Default box will return
button in the TCP/IP
Lorain Power System (AP6C55CA/CB)
User Manual