Table of Contents
Advertisement
6. SETUP PROCESS OF A X8 RENTAL DISPLAY
About this chapter
This chapter roughly describes the installation process of the X8 rental display for a base stand (floor mount) or truss (hanging)
configuration. Several process stages refer to one or more of the detailed "Basic setup procedures", page 39.
Floor mount or hanging X8 rental display
The X8 rental tiles can be used in a floor mount or in a hanging rental configuration. These configurations are limited in height,
maximum 3 tiles high for a floor mount and maximum 13 tiles high for a hanging configuration. Furthermore, a floor mount (base
stand) configuration can only be used indoor and must be equipped with a stacker support system at the rear of the display.
W
ARNING
you read, understand and follow all safety instructions mentioned in the chapter "Safety", page 3, of this
installation manual. Furthermore, make sure that all installation requirements for your X8 rental display are
fulfilled, see chapter "Installation requirements", page 11.
C
AUTION
Overview
•
Set up a floor mount X8 rental display
•
Set up a hanging X8 rental display
R5905160 X8 RENTAL DISPLAY 25/02/2013
:
Safety first. Fence off the installation area before starting to install your X8 rental display. Ensure
:
Cover up the LED-wall on-site, to protect from dust and dirt, until the start of the event.
6. Setup process of a X8 rental display
31
Advertisement
Table of Contents
