Table of Contents
Advertisement
4.3
X8 Connection Box
Introduction X8 Connection Box
The X8 Connection Box contains a power supply unit, a distribution interface and a re-sync unit. All together assembled in a rugged
housing. The X8 Connection Box is attached to a mounting plate which makes the replacement of the hole unit, mounting plate with
X8 Connection Box, very easy and without tools.
The power supply requires 200-240 VAC, 50-60 Hz, 3.6 amps at 200 VAC. The X8 Connection Box has 3 data and 3 power output
ports to connect a string of three X8 Modules by using the X8 Module data or power cable string.
Input/output ports of the X8 Connection Box
The illustration below shows the different connection ports of the X8 Connection Box.
1
Image 4-8
1
Display.
2
Data output to next X8 Connection Box (must be sealed if not used!)
3
Data input (from digitizer or previous X8 Connection Box)
4
Module data ports 1, 2, and 3.
5
Module power ports 1,2, and 3.
6
Power output socket (to next X8 Connection Box. Must be sealed if not used!)
7
Power input socket (from power box or previous X8 Connection Box)
X8 Connection Box orientation
The X8 Connection Box must always be vertically installed with the carrying handle (reference 1) upwards as illustrated (image 4-9).
Image 4-9
Using an X8 Connection Box as stand alone re-sync unit
The X8 Connection Box acts like a stand alone re-sync unit in case no power is applied to the power input socket of the X8 Connection
Box. When you use the X8 Connection Box as stand alone re-sync unit ensure to place dummy plugs upon the power input and
R5905160 X8 RENTAL DISPLAY 25/02/2013
2
3
1
4
5
4. Components of a X8 Rental Tile
6
7
21
Advertisement
Table of Contents
