Cisco CRS User Manual page 249

Software Authentication Manager Commands
If you do not respond to the prompt, the SAM waits for the specified interval to expire, and then it takes the
action specified in the sam prompt-interval command (either the proceed or terminate keyword).
If you enter the command with the proceed keyword, the SAM waits for the specified interval to expire, and
then it proceeds as if you had given a "yes" response to the prompt.
If you enter the command with the terminate keyword, the SAM waits for the specified interval to expire,
and then it proceeds as if you had given a "no" response to the prompt. This use of the command keeps the
system from waiting indefinitely when the system console is unattended.
Note After the software has booted up, the time-interval argument set using this command has no effect. This
value applies at boot time only.
Task ID
Task ID
crypto
Examples The following example shows how to tell the SAM to wait 30 seconds for a user response to a prompt and
then terminate the requested SAM processing task:
RP/0/RP0/CPU0:router/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# sam prompt-interval 30 terminate
Related Commands
Command
show sam sysinfo, on page 253
OL-24740-01
Operations
read, write
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
Description
Displays the current status information for the SAM.
sam prompt-interval
239