Toyota 4A-FE Repair Manual page 68

EM-84
Knock Pin
Installation Marks
Timing Mark
ENGINE MECHANICAL - Cylinder Head
(4A~E)
EM7740
f.M7741
EM7129
EM734'
EM734
(I)
Turn the exhaust camshaft clockwise, and set it with
the knock pin facing upward.
(m) Check that the timing marks of the camshaft gears
are aligned.
HINT: The
assem~ly
installation marks are. on the upside.
4 . . CHECK AND ADJUST VALVE CLEARANCE
(See page EM-16)
Turn the camshaft and position the cam lobe upward, and
check and adjust the valve clearance.
Valve clearance (Cold):
Intake 0.15 - 0.25 mm (0.006 - 0.010 in.)
Exhaust 0.20 - 0.30 mm (0.008 - 0.012 in.)
5. INSTALL ENGINE HANGERS
Install the two engine hangers with the
two
bolts.
Torque: 280 kg-cm (20 ft-lb, 27 N·m)
6. INSTALL FAN BELT ADJUSTING BAR
Install the adjusting bar with the two bolts.
Torque: 200 kg-cm (14 ft-lb, 20 N·m)
7. INSTALL CAMSHAFT TIMING PULLEY
(See step 1 on page EM-44)
8. INSTALL TIMING BELT
Align the matchmarks of the timing belt and camshaft
timing pulley.
(a) Remove any .oil or water on the camshaft timing
pulley, and keep it clean.
(b) Install the timing belt, insuring the tension between
the crankshaft timing pulley and camshaft timing
pulley.