Toyota 4A-FE Repair Manual page 74

EM-90
Seal Diameter
2 - 3 mm (0.08 - 0.12 in.)
ENGINE MECHANICAL - Cylinder Head (4A-FE)
23. INSTALL WATER OUTLET
(a) Remove any old packing (FIPG) material and be care-
ful not to drop any oil on the contact surfaces of the
water outlet cylinder head.
• Using
a
razor blade and gasket scraper, remove all
the oil packing (FIPG) material from the gasket sur-
faces and sealing groove.
• Thoroughly clean all components to remove all the
loose material.
• Using a non-residue, clean both sealing surfaces.
(b) Apply seal packing to the water outlet groove.
Seal packing: Part No. 08826-00100 or equivalent
• Install a nozzle that has been cut with a
2 -
3 mm
(0.08 - 0 .1 2 in.) opening.
HINT: Avoid applying an excessive amount to the sur-
face.
• Parts must be assembled within 1 5 minutes of
application. Otherwise the material must be
removed and reapplied .
.__ _ _ _ _ _ _ __
_ _ _ _ _ _ eM_ 4
_09___,-, •
Immediately remove nozzle from the tube and
EM7036
reinstall cap.
(c) Install the water outlet with the two bolts.
Torque: 150 kg-cm (11 ft-lb, 15 N·m)
24. INSTALL EXHAUST MANIFOLD
(2WD)
(a} Install the lower heat insulator to the exhaust
manifold with the three bolts.
(b) Install a new gasket and the exhaust manifold with
the two bolts and three nuts.
Torque: 250 kg-cm (18 ft-lb, 25 N·mt