Toyota 4A-FE Repair Manual page 179

C0-10
COOLING SYSTEM - Water Pump
C00022 C00023
C00024 C00025
4. INSTALL ROTOR
(a) Install a new packing and seat into the rotor.
(b)
Apply
a
little
LLC
to the seal and rotor contact sur-
face.
(c) Using
a
press, install
a
new rotor on the water pump
bearing shaft.
HINT: As shown in the figure, the distance from the rotor
edge to the installation surface of the pump body should
--...---~-
6 .0
mm be 6.0 mm (0.236 in.).
C00506
C00607
5. CHECK WATER PUMP
After assembly make sure that the rotor rotates smoothly.
6. INSTALL WATER PUMP SUCTION COVER
Install the water pump suction cover on
a new
gasket with
three bolts.
Torque: 92.5 kg-cm (80 in.-lb, 9.1 N·m)
HINT: After installing, make sure that the rotor is not in
contact with the water pump suction cover.