Toyota 4A-FE Repair Manual page 44

EM-60 ENGINE MECHANICAL - Cylinder Head (4A-FE)
6. (4WD)
7. REMOVE DELIVERY PIPE AND INJECTORS
(See steps 3 to 6 and 8 on pages Fl-113 and 114)
8. DISCONNECT ENGINE WIRE FROM N0.3 TIMING
BELT COVER
(a) Disconnect the following connectors and wire :
• Alternator connector
• Alternator wire
• Oil pressure switch connector
(b) Remove the bolt.
(c) Disconnect the wire clamp from the wire bracket, and
EM7o3s
disconnect the engine wire from the timing belt
'------~~~~~~~~~~~~---='"'----'----'
EM7306
EM/593
cover.
9. DISCONNECT ENGINE WIRE FROM INTAKE
MANIFOLD
(a) Disconnect the following connectors :
{b)
(c}
• Throttle position sensor connector
• ISC valve connector
• (2WD w/ EGA system}
EGR VSV connector
• Cold start injector connector
Disconnect the wire clamp from the vacuum pipe.
Remove the three bolts, and disconnect the engine
wire from the intake manifold .
10. (4WD)
11. REMOVE INTAKE MANIFOLD
(2WD)
(a) Remove the two bolts and manifold stay.