Toyota 4A-FE Repair Manual page 33

ENGINE MECHANICAL - Timing Belt (4A-FE)
EM-39
TIMING BELT (4A-FE)
COMPONENT
No.3 Timing Belt Cover
Water Pump
Pulley
No.2 Timing Belt Cover
Drive Belt
, ~
111
"<:,
~
\
Crankshaft Pulley
, ,200 (87, 118)
I
kg-cm (ft-lb, N·m)
I:
Specified torque
Camshaft Timing Pulley
soo
(43,
se)
I
Tension
Spring
Crankshaft Timing Pulley
REMOVAL OF TIMING BELT
EMB978
1. REMOVE DRIVE BELT AND WATER PUMP PULLEY
2. REMOVE SPARK PLUGS (See page IG- 7)
3.
REMOVE CYLINDER HEAD COVER
(See steps 8 and 12 on pages EM-60 and 62)
4. SET N0.1 CYLINDER TO TDC/COMPRESSION
(a) Turn the crankshaft pulley and align its groove with
the timing mark "O" of the No.1 timing belt cover.
(b}
Check that the hold of the camshaft timing pulley is
aligned with the timing mark of the bearing cap.
If not, turn the crankshaft one revolution (360°).