Toyota 4A-FE Repair Manual page 144

Fl-126 EFI SYSTEM - Air Induction System
Fl4311
INSTALLATION OF THROTTLE BODY
1. INSTALL THROTTLE BODY
(a) Connect No.1 water by-pass hose.
(b) Install a new gasket and the throttle body with the
two bolts and nuts.
Torque: 220 kg-cm
~16
ft-lb, 22
N·ml
2. CONNECT FOLLOWING HOSES:
(a) No.2 water by-pass hose.
(b) PCV hose to the throttle body.
(c) Vacuum hose(s) to the port(s).
3.
CONNECT THROTTLE POSITION SENSOR
CONNECTOR
4. INSTALL CABLE BRACKET TO THROTTLE BODY
5. CONNECT AIR CLEANER HOSE
6.
(A/T)
CONNECT THROTTLE CABLE, ANO ADJUST IT
7. CONNECT ACCELERATOR CABLE, AND ADJUST IT
8. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
9. FILL WITH ENGINE COOLANT (See page C0-6)