Toyota 4A-FE Repair Manual page 220

A-2 SERVICE SPECIFICATIONS - Engine Mechanical (4A-FE)
ENGINE MECHANICAL (4A-FE)
Specifications
Engine tune-up
Drive belt (Alternator)
Deflection New belt
Used belt
Tension (Reference) New belt
Used belt
Engine coolant capacity (w/ Heater)
Engine oil capacity
AE MIT
AE A / T
AT171
AT180
w l o Oil cooler Drain and refill
w/ Oil cooler
w / o Oil filter change
w/ Oil filter change
Dry fill
Drain and refill
w/ o Oil filter change
w/
Oil filter change
Dry fill
Engine oil AP! grade
Europe and Australia
Others
Battery specific gravity
High-tension cord resistance
Spark plug
Type
Limit
ND
8 .5 - 10.5 mm
1 0.0 - 12 .0 mm
60 - 70
kg
0.335 - 0 .413 in.
0 .394 - 0.4
7 2
in.
40 - 55 kg
6.2 liters 6 .5 US qts 5.5 Imp. qts
6.1 liters 6.4 US qts 5.4 Imp. qts
5 .6
liters 5 .9 US qts 4.9
Imp.
qts
5 .2 liters 5.5 US qts 4 .6 Imp. qts
3 .0 liters 3.2 US qts 2.6 Imp. qts
3.3 liters 3.5 US qts 2.9 Imp. qts
3 .7 liters 3.9 US qts 3.3 Imp. qts
3.0 liters 3 .2 US qts 2.6 Imp. qts
3.3 liters 3.5 US qts 2 .9 Imp. qts
4.1 liters 4.3 US qts
3.6 Imp. qts
SE, SF, SG or better
SD, SE, SF, SG or better
1 .25 - 1.27 when fully charged at 20°C (68°F)
25 k!l per cord
01 6R-U
NGK BCPR5EY
Intake
manifold
vacuum
Gap
Distributor (llA)
Air
gap
Pickup coil resistance
Ignition timing
Firing order
Valve clearance
Idle speed
VF voltage
Idle CO concentration
Dash pot setting speed
M/T
A/ T
at idle speed
Intake
Exhaust
w/ TWC
w / o TWC
0.8 mm
0 .2 mm or more
140 - 1
ao n
10° BTDC
@
idle
0 .031 in .
0 .008 in. or more
(w/ Terminals TE1 and E1 connected)
1 - 3 - 4 - 2
0.15-0.25mm
0.20 - 0.30 mm
0.006 - 0.01 0 in.
0 .008 - 0.01 2 in.
800 rpm (w/ Cooling fan OFF)
2 .5 ±
0 .7
v
0 - 0.5 %
1.5 ± 0.5 %
1 ,800 rpm (w/ Cooling fan OFF)
2 ,200 rpm (w/ Cooling fan OFF)
More than 440 mmHg (17.32 in.Hg, 58.7 kPa)