Table of Contents
Advertisement
Maintenance
FULL
LOW
Fig. 83: Coolant reservoir
Fig. 83: Radiator
5-14
Checking the coolant level
Proceed as follows:
A
• Park the machine on level ground
• Stop the engine!
• Remove the key and carry it with you
• Let the engine and the coolant cool down
• Open the engine cover
• Check the coolant level on the transparent coolant reservoir A and on the radiator B
If the coolant level is below the LOW seam or if there is no coolant at the radiator's
filler inlet:
• Add coolant
Important
Check the coolant level once a day.
We recommend checking it before starting the engine.
B
Adding coolant
After the engine has cooled down:
Release overpressure in the radiator
Carefully open the cap to the first notch and fully release the pressure
Open filler cap B
Add coolant up to the lower edge of the filler inlet (radiator)
Close filler cap B
Start the engine and let it warm up for about 5 – 10 minutes.
Stop the engine
Remove the key and carry it with you
Let the engine cool down
Check the coolant level again
The coolant level must be between the LOW and FULL reservoir seams
If necessary, add coolant and repeat the procedure until the coolant level remains constant
NOTICE
Do not add a different coolant to the one in the reservoir.
Use only the coolant prescribed by Wacker Neuson
– see chapter 5.13
1501) on page 5-32
– see chapter 5.14
page 5-34.
Important
Check the antifreeze every year before the cold season sets in!
Engine/machine fluids and lubricants (1001 and
Engine/machine fluids and lubricants (2001) on
BA 1001/1501/2001 us – Edition 3.3 * * 12001b510.fm
Advertisement
Table of Contents
