Procedure - Wacker Neuson 1001 Operator's Manual

Procedure

1
0
3
Fig. 27: Preheating start switch
13
Fig. 28: Indicator lights
BA 1001/1501/2001 us – Edition 3.3 * 12001b330.fm
• Do not run the starter for more than 10 seconds
• Wait about 1 minute so the battery can recover before trying again
After you have completed the starting preparations:
Insert the starting key in preheating start switch 3
Turn the starting key to position "1"
2
Check whether the following indicator lights illuminate:
3
Indicator light 9 for engine oil pressure
Indicator light 13 for alternator charge function
Replace malfunctioning indicator lights immediately.
Turn the starting key to position "2" and hold it in this position until the preheating indi-
cator light goes out
Turn the starting key to position "3" and hold it in this position until the engine starts
9
If the engine does not start after 10 seconds
Interrupt the start procedure and try again after 1 minute
If the engine still does not start after the second try
Contact a Wacker Neuson service center for troubleshooting.
As soon as the engine runs:
Release the starting key
When the engine runs smoothly (increased engine speed):
Operation
3-17