Instructions concerning specific components
Alternator
Battery
+
A
Fig. 102: Battery
BA 1001/1501/2001 us – Edition 3.3 * 12001b530.fm
Cables, bulbs and fuses
Always observe the following instructions:
• Malfunctioning components of the electrical system must always be replaced by a Wacker
Neuson service center. Bulbs and fuses may be changed by unqualified persons
• When performing maintenance on the electrical system, pay particular attention to
ensuring good contact in leads
Always observe the following instructions:
• Only test run the engine with the battery connected
• When connecting the battery, ensure that the poles (+/−) are not inverted
• Always disconnect the battery before performing welding work or connecting a quick
battery charger
WARNUNG
WARNING
W
Explosion hazard when working on the electrical system!
Can cause severe injury or death.
•
Wear protective gloves and safety glasses.
•
Do not attempt to jump-start the machine if the battery is frozen or if the acid
level is low. The battery can burst or explode. Replace the battery immediately.
•
Always disconnect the negative terminal from the battery before starting repair
work on the electrical system.
Battery A is located under the engine cover. The battery is "maintenance-free". However
have the battery checked at regular intervals to ensure that the electrolyte level is between
the MIN and MAX marks.
-
Checking the battery requires it to be removed and must be performed by a Wacker Neu-
son service center.
Always follow the specific battery safety instructions!
Important
Do not disconnect the battery while the engine is running!
Maintenance
5-29