Stvo Accessories (Option); Reversing Signal (Option); Before Starting The Engine; General Information On Starting The Engine - Wacker Neuson 1001 Operator's Manual

Operation

StVO accessories (option)

Reversing signal (option)

Before starting the engine

General information on starting the engine

3-16
Scope of delivery of StVO accessories:
• Headlights and rear lights
• Turn indicators and clearance lights
• Reversing light and reflectors
• Numberplate console and light
• Wheel chock
• Control lever lock
The reversing signal sounds during backward machine travel.
WARNUNG
WARNING W
Accident hazard when traveling forward/backward!
Crushing hazard causing death or severe injury.
• Do not allow anyone to stay in the danger zone.
• Do not rely on the reversing signal under any circumstances.
• If the reversing signal does not sound, stop machine operation immediately
and get in touch with a Wacker Neuson service center (observe the relevant
national regulations).
Adjust your seating position
Important
All controls must be within easy reach. You must be able to press the acceler-
ator and brake pedals to their limit positions!
Fasten your seat belt – see
Check whether all levers and pedals are in neutral position
Press the accelerator pedal to the center position (between minimum and maximum) if
the engine is cold
Important
The model 1001 and 1501 engine will not start unless the parking brake is
applied and the brake pedal is pressed at the same time.
• 1001: from serial no. EA03289.
• 1501: from serial no. WNCD0105TPAL00166.
• Besides, the starter cannot be actuated if:
• the engine is already running (start repeat interlock),
• the travel lever is not in neutral position,
• the parking brake is not applied.
1001: up to serial no. EA03288.
1501: up to serial no. WNCD0105TPAL00165.
• the parking brake is not applied (2001).
– see Seat adjustment on page 3-27
Seat belt on page 3-28
BA 1001/1501/2001 us – Edition 3.3 * * 12001b330.fm