Indicator Lights And Warning Lights (Overview) - Wacker Neuson 1001 Operator's Manual

Indicator lights and warning lights (overview)

BA 1001/1501/2001 us – Edition 3.3 * 12001b320.fm
14 Indicator light (red) – hydraulic oil filter
Indicates inadmissibly high pressure in the hydraulic return line to the reservoir. In this case:
Have the hydraulic oil return filter checked and, if necessary, replaced by a Wacker
Neuson service center
The indicator light can illuminate briefly if the hydraulic oil is cold, but goes out again
once operating temperature is reached.
8 Indicator light (red) – alternator charge function
NOTICE
The coolant pump no longer runs if the V-belt is faulty. Danger of engine over-
heating or breakdown!
If the indicator light illuminates with the engine running:
Stop the engine immediately and
Have the cause repaired by a Wacker Neuson service center
The V-belt is malfunctioning or there is an error in the charging circuit of the alternator if
the indicator light illuminates with the engine running. The battery is no longer charged.
9 Indicator light (red) – engine oil pressure
Illuminates if the engine oil pressure is too low. In this case:
Stop the machine
Stop the engine immediately and check the oil level
The indicator light illuminates when the starter is turned on and goes out as soon as the
engine runs.
11 Indicator light (red) – coolant temperature
WARNUNG
W WARNING
Burn hazard! The engine coolant is under pressure at high
temperature.
Can cause severe injury or death.
• Wait at least 10 minutes after stopping the engine.
• Wear protective gloves and clothing.
• Open the cap to the first notch and release the pressure.
15 Indicator light (yellow) – preheating
Illuminates if the key in the preheating start switch is in position 2.
A glow plug preheats the air in the combustion chamber of the engine when the key is in
this position.
The indicator light goes out as soon as preheating temperature is reached (15 – 20 sec)
Operation
3-13