Table of Contents
Advertisement
Safety Information
2.9
Trailering and Transport
Trailers
Transport
2.10 Temperature Range
2.11 Safety Guidelines for Maintenance
General maintenance notes
2-12
• Even though the dumper is equipped with towing gear, it is not a tractor and may not be
used as such in difficult terrain.
• If the dumper is used on construction sites for towing trailers, weight the skip with 25 %
of the payload. However, do not exceed the dumper's maximum payload with the
combination of towed equipment and the weight in the skip!
• Secure the towing pin of the towing gear with a split pin.
• Use special care when coupling trailers, and couple them with the specially required
devices only.
• Always secure trailers against unintentional movement.
• If optional equipment such as a trailer is installed, make sure that all lights and
associated indicator lights are installed and functional.
• The machine must be towed, loaded and transported only in accordance with
procedures described in this Operator's Manual.
• For towing the machine, observe the prescribed transport position, admissible speed
and itinerary.
• Make sure that the vehicle transporting the machine has a sufficient capacity and
payload.
• Safely secure the machine on the transporting vehicle. Use the specified tie-down
points.
The machine may only be used between a maximum +45°C (113°F) and minimum -15°C
(5°F). Contact your Wacker Neuson dealer if you intend to use the machine in other
temperature ranges. Store the machine in a dry place at room temperature (about 15°C, or
59°F). Observing these temperature ranges will help to prolong the machine's service life.
• Adhere to prescribed intervals or those specified in this Operator's Manual for routine
checks/inspections and maintenance.
• For inspection and maintenance, ensure that all tools and workshop equipment are
adapted to the task that must be performed.
• Replace hydraulic hoses within stipulated and appropriate intervals even if no
safety-relevant defects have been detected.
• Make sure all consumables and replaced parts are disposed of safely and with
minimum environmental impact.
• Always tighten any screws, electrical connections, or hose connections that may have
been loosened during maintenance.
• Upon completion of the maintenance on or with the machine, immediately refit and
check any safety devices removed for set-up or maintenance purposes.
BA 1001/1501/2001 us – Edition 3.3 * * 12001b210_us.fm
Advertisement
Table of Contents
