Option 41 Triple-Input Audio - Tektronix VM700T User Manual

Option 41 Triple-Input Audio

Configuring Source Selection Audio
VM700T Option 40/41/42 Audio Measurements User Manual
This section describes the differences in operation between Option 40 and
Option 41, and it gives the verification procedure for Option 41.
The Option 41 software is similar to the Option 40 software except for the
Source Selection Audio file.
The Source Selection Audio file lets you specify an Option 41 audio input (1, 2,
3) for a video source (A, B, C), and then select an appropriate audio source file
(if you want to use an audio source file other than the system default).
In the next steps you want to have source A to audio input 1, source B to 2, and
source C to 3.
To specify audio inputs and audio source files for video sources, use the
following procedure:
1. From Measure Mode, press the Configure front-panel button, touch the
soft key followed by the
key.
2. Rotate the front panel knob to highlight the source (A, B, C) for which you
are specifying an audio input and an audio source file.
3. Touch the highlighted audio input (1, 2, or 3) to select it.
4. Rotate the front-panel knob to change the audio input selection.
5. Touch the highlighted source file to select it.
6. Rotate the front-panel knob to change the audio source file selection (if you
are using an audio source file other than the system default).
7. When you have specified the audio inputs and source files, touch the
soft key.
8. If the change is correct, touch the
the soft key.
soft
soft key, otherwise, touch
B-9