Tektronix VM700T User Manual page 24

VM700T Option 40/41/42 Audio Measurements User Manual
2. Touch the appropriate soft key for the file you want to use (for example,
).
3. The screen displays a keyboard that you can use to type the name for your
new file as shown previously in Figure 1–5 on page 1–5. Follow the file
naming suggestions given on page 1–4.
4. Press the soft key.
The VM700T now displays the contents of the new file containing the audio
source data from the file you selected as the template. You can modify the
parameters in this file.
Changing the Audio Source Parameters. Change the Audio Source parameters
using the following procedure:
1. Rotate the knob to highlight the line containing the parameter you want to
change.
2. Select a parameter by touching it.
3. Rotate the knob to change the parameter or value.
4. Touch the
NOTE. If you change a parameter and then decide you do not want to keep the
change, press the
want to exit without changing anything by asking you to touch the
soft key again.
To return to the file you created, touch the soft key on the display (the file you
created now appears there).
If you are making extensive changes to the file, you can avoid losing all your
changes by pressing the
re-entering the file. That way, if you make a mistake and must exit the file, your
earlier work will be retained while the most recent change (or mistake) is
eliminated.
soft key to accept the change.
soft key. The VM700T verifies that you
soft key after each change and then
Getting Started
1–9