Figure 2-18: Ferrite Forms Installed On The Signal Interconnection Cable - Tektronix VM700T User Manual

Option 41 and Option 42
2–32
Installation Instructions. Install the ferrite cores after assembling the cable to the
supplied connector. Use the included tie wraps to hold the two ferrite halves in
place on the cable.
1. Place a cable tie wrap around the cable with the tie wrap end started through
the tie binder to form a loop.
2. Place both ferrite forms on the cable as shown in Figure 2–18. The parts
must be placed as close to the to the connector as possible.
3. Slide the loop of the tie wrap over the two ferrite halves and tighten the tie
wrap firmly. Trim off the excess end of the tie wrap.
4. Place an additional tie wrap around the cable behind the ferrite forms to
eliminate the possibility of the assembled parts slipping on the cable.
Tighten the tie wrap on the cable and trim off the excess end.
Figure 2–18: Ferrite forms installed on the signal interconnection cable
VM700T Option 40/41/42 Audio Measurements User Manual