Command Format; Audio Remote Commands; Execute Application - Tektronix VM700T User Manual

Remote Commands and Keywords

Command Format

Audio Remote Commands

execute application

3–2
NOTE. The following material is an abbreviated explanation of the remote
commands. It assumes that you understand the principles of remote VM700T
operation and have access to the VM700T RS-232 Interface Programmer
Manual and, if applicable, the VM700T Option 48 GPIB Interface Programmer
Manual.
The VM700T remote control commands use this form:
The is the actual command name. Variable values are shown in italic.
Optional arguments are enclosed with [ ]. A discussion of command usage and
arguments follows the command header.
Note that, for serial remote control, VM700> is a prompt from the VM700T
(which you can change), not an input. With Option 48, any prompt you see
depends on the GPIB controller programming, it is not a return from the
VM700T.
Once in communication with the VM700T, the following remote commands can
be used with the Audio option.
The command starts the specified VM700T application. An application
is one of the executable files (with exceptions noted below) found in the
Instrument~Operations, VM700~Diagnostics, Video~Measurements, or
Audio~Measurements directories in the Executable~Files directory. Selecting an
operational mode application, such as Vector, is equivalent to pressing the front
panel button; the LED on the selected button is lit. Selecting a measurement or
diagnostic application is equivalent to touching the selection soft key.
Example:
You may run the following audio applications under remote control. Be sure to
use the same capitalization and tildes (~) as shown:
VM700T Option 40/41/42 Audio Measurements User Manual