Set Keyword [Channel_Letter] Value1 [Value2; Show Filename; Softkey Softkey_Name - Tektronix VM700T User Manual

Remote Commands and Keywords
set keyword
[channel_letter]
value1 [value2 ...]

show filename

softkey
softkey_name
3–4
NOTE. The Configure, Function, and Measure buttons cannot be selected
through remote.
The command defines the configuration values to be used during the remote
session. The keywords available for
Table 3–3. The channel_letter is A, B, or C. The configuration values changed
with remain in effect until they are restored to their original (preremote)
values with the
switched off and back on. Note that the system line and other global variables
can be changed with
Example:
The above example changes the limits for channel A insertion gain from their
previous values to –0.5 and 0.5.
The command returns the contents of the specified filename. The default
path is the Measurement~Results directory. Other files can be specified with a
full pathname or a path relative to the Measurement~Results directory.
Example:
The command (soft key used as one word) indicates the press and
release of a specified soft key, such as
equivalent to entering
should be used instead of these commands.
Example:
With a few exceptions, the general rule for forming a softkey_name is to take the
spelling and capitalization from the soft key name on the display, omit the
variable part and join the words with _ (underscore). For example, the
softkey_name for the
it is H_Display.
VM700T Option 40/41/42 Audio Measurements User Manual
are listed in Table 3–1, Table 3–2, and
command, or power to the instrument is
but are not restored with
. Using the
and
soft key is Noise_dB, and for
.
command is
; however, in general