Removing The 2145 Ups-1U Front Panel; The 2145 Ups-1U Internal Battery Connector With Protective Tape - IBM 2145UPS-1U Hardware Installation Manual

|
|
3. If you have not already connected the internal battery connector, remove the
2145 UPS-1U front panel.
Figure 19. Removing the 2145 UPS-1U front panel
4. Remove the protective label from the internal battery connector.
Figure 20. The 2145 UPS-1U internal battery connector with protective tape
5. Connect the internal battery connector. Each end of the keyed connector has
two wires: one red (+) and one black (−). Join the black wires and the red wires
together.
Note: A small amount of arcing might occur when connecting the batteries.
This is normal and does not damage the unit or present any safety
concerns.
Chapter 6. Installing the SAN Volume Controller 2145-8G4 hardware
45