Verifying The San Volume Controller 2145-8F4 Or The San Volume Controller 2145-8F2 Installation; Connectors At The Back Of The San Volume Controller 2145-8F4; Connectors At The Back Of The San Volume Controller 2145-8F2 - IBM 2145UPS-1U Hardware Installation Manual

2. Connect the other end of the Ethernet cable to the proper connector on the
Ethernet hub or switch.
Figure 68. Connectors at the back of the SAN Volume Controller 2145-8F4
1
Fibre-channel port 1
2
Fibre-channel port 2
3
Fibre-channel port 3
4
Fibre-channel port 4
5
Ethernet port 1
Figure 69. Connectors at the back of the SAN Volume Controller 2145-8F2
1
Ethernet port 1
2
Low profile duel port fibre-channel host bus adapter (HBA) with ports 1
and 2 (left to right)
3
Full height duel port fibre-channel HBA with ports 3 and 4 (left to right)
Attention:
straps or bend the cables to a radius smaller than 76 mm (3 in.).
3. Connect the fibre-channel cables to the fibre-channel ports as required by the
user's configuration.
4. Connect the other ends of the fibre-channel cables to the proper connectors of
the fibre-channel switches.
Complete steps 1 on page 94 through 4 for each node that you need to connect to
the SAN and to the Ethernet network.
Verifying the SAN Volume Controller 2145-8F4 or the SAN
Volume Controller 2145-8F2 installation
You must verify the SAN Volume Controller installation after the installation has
completed.
Appendix A. SAN Volume Controller 2145-8F4 and SAN Volume Controller 2145-8F2
1
2
5
1 2 3
When routing the fibre-channel cables, do not tighten the cable
3
4
95