Table of Contents
Advertisement
Installing the SAN Volume Controller 2145-8G4 in a rack
|
|
|
|
52
IBM System Storage SAN Volume Controller: Hardware Installation Guide
2
Figure 30. Attaching the slide rail to the rear mounting flange
The installation of the support rails for the SAN Volume Controller 2145-8G4 is
complete.
After installing the support rails, you can install the SAN Volume Controller
2145-8G4 in the rack.
CAUTION:
To avoid any hazard from the rack tipping forward when devices are installed,
observe all safety precautions for the rack into which you are installing the
device.
Perform the following steps to install the SAN Volume Controller 2145-8G4, which
is also called a "node", in the rack:
1. Extend the slides approximately 150 mm (6 inches) from the front of the rack
cabinet.
2. Remove the protective metal guard and the shipping bracket from the back of
the node.
3. Align the two rear wheels on the node with the opening in the slides and then
push the node into the slides until the rear slide release latches
place, locking the node in the slides.
Note: If two people are available, one person can stand on either side of the
node to lift it into the rack.
2
click into
Hide quick links:
Advertisement
Table of Contents
