IBM 2145UPS-1U Hardware Installation Manual page 169

3
Latch-lever
6. Place the front end of the left rail in the rack cabinet. Align the top of the
1
front bracket (Figure 94) with the required EIA marking that is on the
rack.
2
1
Figure 94. Installing the front end of the rail
1
Front bracket
2
Rack-mounting flange
3
Locating pins
7. Align the locating pins
flange.
8. Push the latch lock
the carrier. The latch-lock carrier slides toward the front of the rack and the
locating pins project through the holes that are in the front flange and in the
front rail bracket.
Important: Ensure that the locating pins are fully extended through the front
rail bracket.
3
3
with the holes that are in the rack-mounting
2
(Figure 95 on page 132) away from the rail to release
Appendix B. SAN Volume Controller 2145-4F2
131