AEMC OX7102-CII User Manual page 6

General instructions (cont'd)
Warranty
Maintenance and
metrological
verification
Unpacking -
Repacking
Cleaning
Update the instrument's internal software
I - 6
This equipment is guaranteed for 3 years against any defect in materials or
workmanship, in accordance with the general terms and conditions of sale.
During this period, the equipment can only be repaired by the manufacturer.
The manufacturer reserves the right to carry out repair or replacement of all or
part of the equipment. If the equipment is returned to the manufacturer, initial
transport costs shall be borne by the customer.
The warranty does not apply following:
• unsuitable use of the equipment or use with other incompatible equipment
• modification of the equipment without explicit authorization from the
manufacturer's technical services
• repair carried out by a person not certified by the manufacturer
• adaptation to a specific application, not provided for in the definition of the
equipment or by the operating manual
• an impact, a fall or a flooding.
Before the equipment is opened, it must be disconnected from the AC power
supply and the measurement circuits, and the operator must not become
charged with any static electricity. This could cause the destruction of internal
parts.
Any adjustment, servicing or repair of the unit under power must be undertaken
only by qualified personnel, after reading the instructions in this manual.
A qualified person is a person who is familiar with the installation, its
construction, its use and the hazards that exist. They are authorized to activate
and deactivate the installation and equipment, in compliance with the safety
instructions.
Information and contact details, contact your nearest distributor.
All the equipment was verified mechanically and electrically before shipping.
When you receive it, carry out a quick check to detect any damage that may
have occurred during transport. If necessary, contact our sales department
immediately and register any legal reservations with the carrier.
In the event of reshipping, it is preferable to use the original package. Indicate
the reasons for the return as clearly as possible in a note attached to the
equipment.
• Turn the instrument off.
• Clean it with a damp cloth and soap.
• Never use abrasive products or solvents.
• Allow to dry before any further use.
• Log on to the
www.aemc.com
• From the Home page, select "Software and Firmware Updates".
• Select and download the Firmware corresponding to your instrument model.
• Also download the installation instructions for this Firmware.
• Refer to these instructions to update your instrument.
website.
General Instructions
SCOPIX Oscilloscopes