Specifying Ppp Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 ADSL2 Testing
Testing Data services
Specifying PPP
settings
34
6 Select NAT Refresh and then specify the NAT refresh
rate. This is the number of seconds between messages to
the STUN server to keep the NAT mapping alive.
The STUN settings are specified.
NOTE:
If STUN is enabled, the data layer will not come up until the
STUN client on the HST has determined the type of NAT
used between the HST and the STUN server.
The following procedure describes how to specify the point-to-
point protocol (PPP) settings. If you are using Multi VLAN data
mode, you may have more than one PPP screen (for
example, PPP2, PPP3).
To specify the PPP settings
1 Press the PPP soft key.
The PPP Settings menu appears.
2 Select PPP Mode, and then select either Client or
Server.
HST-3000 ADSL2 Testing User's Guide