Graphs; Identity Results - JDS Uniphase HST-3000 User Manual

Graphs

Identity results

The graphs provide a graphical representation of the bits per
tone (BPT). It is available in standard range and extended
range. In addition, if using the Infineon or Broadcom SIMs,
H.log, or quiet line noise (QLN) graphs are available.
shows an example of the standard range BPT graph.
Figure 2 BPT graph
This category provides the HST-3000 modem firmware revi-
sion information, and the following information from the
DSLAM (when synchronized).
results.
Table 12 Identity results
Result
Modem Firmware
Modem Revision
Modem Data-
pump
Far vendor ID
Far vendor rev
Far vendor name
1. Only displayed on Conexant SIMs
2. Only displayed on TI SIMs
HST-3000 ADSL2 Testing User's Guide
Chapter 3 Interpreting Test Results
Table 12
Description
The ID of the internal modem
The firmware rev of the internal modem
The rev of the datapump of the internal
2
modem
The ID of the far end modem
The firmware rev of the far end DSLAM
The name of the DSLAM (drawn from the
DSLAM)
Modem emulate results
Figure 2
describes the identity
1
63