Specifying Test Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 ADSL2 Testing
Testing in modem emulate mode
Specifying test
settings
12
Before you begin testing, make sure the test settings on the
HST-3000 match the settings of the line you are testing.
To specify test settings
1 Access the ADSL testing options (see
2 Select ADSL Modem mode.
After a few seconds the ADSL Summary statistics menu
appears. The unit is now in modem emulate mode.
3 Press the Configure
The parameter soft keys appear.
4 Press the GENERAL soft key. You may need to use the
left or right arrow buttons to find the General soft key.
The ADSL General Settings menu appears.
This menu varies, depending on the ADSL SIM you are
using (which chip set), and the version of modem soft-
ware installed.
5 Optional. To restore the settings to factory defaults, do the
following. To change individual settings, go to
a Select Restore Defaults.
b At the restore defaults prompt, press the OK key.
HST-3000 ADSL2 Testing User's Guide
page
navigation key.
10).
step 6.