Throughput Testing; Atm Bert Testing - JDS Uniphase HST-3000 User Manual

Chapter 2 ADSL2 Testing
Testing Data services
Throughput
testing
ATM BERT
testing
44
5 Press the Actions soft key.
6 Select either Log-Off or IP-Release.
The Log-Off and IP-Release options are only available
when you viewing the IP results window.
The IP address is now available for use in other applica-
tions.
Using the FTP/HTTP throughput feature, you can perform a
file transfer to test the throughput of the circuit.
To test throughput
1 Specify the FTP/HTTP settings (see
HTTP settings" on page
2 Navigate to the FTP/HTTP results screen.
3 Press the Actions soft key.
4 Select FTP/HTTP and then Enter Address.
5 Enter the address using the keypad, including the prefix
(ftp: or http: or, if applicable, https:) and the filename.
For example, ftp://10.0.0.1/name
6 Press OK to begin the file transfer.
The throughput results appear on the screen.
See "FTP/HTTP results" on page 76
preting the results.
The HST-3000 allows testing of the ATM layer using a bit error
rate test (BERT). The following procedure describes how to
perform an ATM BERT.
To perform an ATM BERT test
1 Verify that ATM BERT is selected as the Data Mode. See
"Specifying data settings" on page
HST-3000 ADSL2 Testing User's Guide
"Specifying FTP/
37).
for information on inter-
26.