Specifying Trace Route Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 ADSL2 Testing
Testing Data services
Specifying trace
route settings
36
The Ping Settings menu appears.
2 Select Address Type, then select either IP Address or
DNS Name (domain name server name).
IP Address uses the numeric address, DNS Name uses
the domain name, such as www.jdsu.com
3 Select IP Address, and then enter the IP address.
JDSU recommend using the IP address or Domain Name
Services (DNS) name of the ISP gateway of the
customer's service provider. It is also possible to ping any
internet address or the network Broadband Remote
Access Server (BRAS).
4 Select DNS Name, and then enter the DNS name.
5 Select Number Pings, and then set the number of pings
to send before stopping.
6 Select Pings/second, and then set the number of pings
per second.
7 Select Packet size, and then set the packet size.
The default is 16. Change this only if needed.
The ping settings are specified.
The following procedure describes how to specify trace route
settings. For all modes except TE mode, the WAN interface is
the DSL connection to tip and ring.
HST-3000 ADSL2 Testing User's Guide