Specifying Wan Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 ADSL2 Testing
Testing Data services
Specifying WAN
settings
30
The following procedure describes how to specify the wide
area network (WAN) settings. The WAN interface is the DSL
connection to tip and ring. The WAN settings are only avail-
able when the Emulation Type is set to Through.
The WAN Settings menu appears if you are using IPoE or
Multi VLAN data mode. For Multi VLAN data mode, you may
have more than one WAN screen (for example, WAN2,
WAN3).
To specify WAN settings
1 Press the WAN soft key.
The WAN Settings menu appears.
The menu items vary depending on the Data mode.
NOTE:
If you selected PPPoA or Bridged Ethernet as the Data
mode, the WAN settings are not applicable, and thus the
WAN tab is not displayed.
If you are using Multi VLAN data mode, the first item is
Interface Mode but is not selectable. It is auto populated
from the Data Settings menu "Interface x Mode" selection.
2 If you are using IPoE or IPoA data mode, select IP Mode,
then select either Static or DHCP (dynamic host configu-
ration protocol).
If you selected DHCP, do the following.
HST-3000 ADSL2 Testing User's Guide