Specifying Lan Settings - JDS Uniphase HST-3000 User Manual
Adsl2 testing
Hide thumbs
Also See for HST-3000:
- User manual (356 pages) ,
- Testing manual (24 pages) ,
- Instruction manual (14 pages)
Table of Contents
Advertisement
Chapter 2 ADSL2 Testing
Testing Data services
Specifying LAN
settings
28
8 If you are testing in Multi-VLAN data mode, select Inter-
face x Purpose, and then specify the purpose for that
sub-interface (Internet, Video, or Voice).
9 Repeat steps
10 Select VC, and then enter the virtual path indicator (VPI)
and virtual channel indicator (VCI) for the virtual channel
(VC) under test.
11 If you selected IPoE, IPoA, PPPoA, PPPoE, MVC Video,
or Bridged Ethernet Data Mode, select TX ATM PCR and
enter the transmit peak cell rate.
– Unlimited transmits the maximum cell rate allowed on
the circuit.
– User Specified allows you to enter a value from 2 to
50000 cells per second.
NOTE:
If the rate entered is not attainable, the HST will round
down to the next attainable rate.
12 If you selected IPoE, IPoA, PPPoA, or PPPoE Data
Mode, select Encapsulation, and then specify the appro-
priate setting.
NOTE:
Depending on previous settings, you may have to navigate
to item 10 on the menu, and then press the down arrow to
find this selection.
13 If you selected ATM Loopback Data Mode, select Loop-
back Mode and specify whether to loop ALL cells or only
TTC cells.
The data settings are specified.
The following procedure describes how to specify the LAN
settings. The LAN settings are only available in Through mode
(when the Data Emulation Type is set to Through).
HST-3000 ADSL2 Testing User's Guide
7
and
8
for any remaining interfaces.
Advertisement
Table of Contents
