Verifying Proper Operation; Observing The Power Status Leds - Brocade Communications Systems FESX624HF Installation Manual

1. Ensure that all power supplies are fully and properly inserted and no power supply slots are uncovered.
Never leave tools inside the device.
2. Remove the power cord from the shipping package.
3. Attach the AC power cable to the AC connector on the rear panel.
4. Insert the power cable plug into a 115V or 120V outlet.
NOTE
To turn the system off, simply unplug the power cords.
NOTE
The socket should be installed near the equipment and should be easily accessible.
NOTE
If the outlet is not rated 115 or 120V, stop and get the appropriate cable for the outlet.

Verifying proper operation

After you have installed any redundant power supplies, verify that the device is working properly by plugging it into a power source and
verifying that it passes its self test.
If your device has more than one power supply installed, repeat this procedure for each power supply.
1. Connect the power cord supplied with the device to the power connector on the power supply on the rear of the device.
2. Insert the other end into a properly grounded electrical outlet.
3. The non-POE devices use power supply model RPS5, which do not have power switches. They power on when you connect a
power cord to the device and to a power source.
If your installation requires a different power cord than that supplied with the device, make sure you obtain a power cord
displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your assurance
that the power cord can be used safely with the device.
4. Verify that the LED for each power supply is a solid green.
5. Verify proper operation by observing the LEDs.
All the port LEDs should flash momentarily, usually in sequence, while the device performs diagnostics. After the diagnostics are
complete, the LEDs will be dark except for the ones that are attached by cables to other devices. If the links on these cables are
good and the connected device is powered on, the link LEDs will light.
For more details on specific LED conditions after system start-up, refer to the section below,
on page 35 and Chapter 6, "Hardware

Observing the power status LEDs

Table 2 lists the LEDs that show power status. The power supplies themselves do not have LEDs.
Brocade FastIron Edge X-Series Hardware Installation Guide
Part Number: 53-1002499-02
Specifications".
Installing a FastIron Compact Switch
Verifying proper operation
"Observing the power status LEDs"
35