Table of Contents
Advertisement
5.
Hold the bar on the front panel of the power supply and pull outward. This will disconnect the power supply from the backplane.
6.
Continue to pull the power supply until it is removed from the device.
7.
Place the power supply in an anti-static bag for storage.
8.
Insert a new supply, or place the cover plate over the empty power supply bay and press the two latches near the edges of the
supply outward to lock the plate into place.
9.
If necessary, replace the power supply locking screw.
Installing an AC power supply
To install an AC power supply, complete the following steps.
1.
If necessary, remove the power supply locking screw located in the center rear of the device (illustrated below).
2.
If the empty power supply bay has a cover plate, press inward on the two latches near the edges of the cover plate to unlock the
plate, then remove the plate.
3.
Remove the power supply from its packaging.
4.
With one hand, hold the bar on the front panel of the power supply. With the other hand, support the underside of the power
supply, and insert the power supply into the empty power supply slot. Press until the supply is completely in the slot, so that the
connectors on the back of the supply are fully engaged with the pins on the power backplane.
Make sure you insert the power supply right-side up. It is possible to insert the supply upside down,
although the supply will not engage with the power backplane when upside down. The power supply is
right-side up when the power connector is on the left and the fan vent is on the right.
5.
Press the two latches near the edges of the supply outward to lock the supply in place.
6.
Connect the power cord to the power supply.
7.
Connect the plug end of the power cord into an outlet.
DC power supplies
Use the following procedures for DC power supplies in FastIron compact devices. Refer to
power supplies are supported in which devices, and for illustrations of power supply placement in the Brocade devices.
Before beginning the installation, refer the precautions in
Brocade FastIron Edge X-Series Hardware Installation Guide
Part Number: 53-1002499-02
Power Supply locking screw
Replacing and Maintaining the Hardware
Replacing a power supply
"Power supplies"
on page 21 for a list of which
"Power precautions"
on page 27.
63
Advertisement
Table of Contents
Troubleshooting
