Support For Digital Optical Monitoring - Brocade Communications Systems FESX624HF Installation Manual

•
For fiber-optic connections, verify that the transmit port on the device is connected to the receive port on the connected
device, and that the receive port on the device is connected to the transmit port on the connected device.
•
For copper ports, you can test the cable using Virtual Cable Testing. For more information, refer to the chapter "Monitoring
Hardware Components" in the <Italic>FastIron Configuration Guide.
•
If the other procedures do not resolve the problem, try using a different port or a different cable.

Support for digital optical monitoring

You can configure the Foundry device to monitor optical transceivers in the system, either globally or by specified port. When this feature
is enabled, the system will monitor the temperature and signal power levels for the optical transceivers in the specified ports. Console
messages and syslog messages are sent when optical operating conditions fall below or rise above the XFP or SFP manufacturer
recommended thresholds. For details about this feature and how to configure it, refer to the section "Digital Optical Monitoring" in the
<Italic>FastIron Configuration Guide.
Brocade FastIron Edge X-Series Hardware Installation Guide
Part Number: 53-1002499-02
Connecting Network Devices and Checking Connectivity
Troubleshooting network connections
51