Brocade Communications Systems FESX624HF Installation Manual page 33

•
Four each 12-24 screws to mount the Brocade device to the rack.
Make sure the rack or cabinet housing the device is adequately secured to prevent it from becoming
unstable or falling over.
Mount the devices you install in a rack or cabinet as low as possible. Place the heaviest device at the
bottom and progressively place lighter devices above.
Complete the following steps to install the rack mount brackets and mount the device in a rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two mounting brackets and several mounting screws.
2. Align the brackets with the screw holes on the sides of the device, then use the screws to attach the mounting brackets. Refer to
the appropriate illustration, depending on which brackets you are installing:
•
Figure 1 shows how to attach the short mounting brackets.
•
Figure 2 shows how to attach the long mounting brackets.
FIGURE 1 Attaching the short mounting brackets
Brocade FastIron Edge X-Series Hardware Installation Guide
Part Number: 53-1002499-02
Installing a FastIron Compact Switch
Installing the device
33