Using A Cx4 Transceiver - Brocade Communications Systems FESX624HF Installation Manual

Connecting Network Devices and Checking Connectivity
Connecting network devices
3. Gently insert the fiber optic module into the port until the module clicks into place. The module is keyed to prevent incorrect
insertion.
Cabling a fiber optic module
Complete the following tasks to cable a fiber optic module.
1. Remove the protective covering from the fiber-optic port connectors and store the covering for future use.
2. Before cabling a fiber optic module, Brocade strongly recommends cleaning the cable connectors and the port connectors. For
more information, refer
3. Gently insert the cable connectors (a tab on each connector should face upward) into the port connectors until the tabs lock into
place.
4. Observe the link and active LEDs to determine if the network connections are functioning properly. For more information about
the LED indicators, refer
Cleaning the fiber-optic connectors
To avoid problems with the connection between the fiber optic module (SFP (mini-GBIC) or XFP) and the fiber cable connectors, Brocade
strongly recommends cleaning both connectors each time you disconnect and reconnect them. In particular, dust can accumulate in the
connectors and cause problems such as reducing the optic launch power.
To clean the fiber cable connectors, Brocade recommends using the fiber-optic reel-type cleaner that shipped with your FastIron chassis.
You can also purchase this type of cleaner from the following Website.
http://www.fisfiber.com/Home_Page.asp
When not using an SFP or XFP connector, make sure to keep the protective covering on.

Using a CX4 transceiver

You can install a twin-axial 10G copper CX4 XFP transceiver in any 10G port. For a link to operate properly, both sides must use identical
CX4 transceivers.
The CX4 transceiver requires a 15 meter CX4-grade cable with 24 or 26 American Wire Gauge (AWG). This cable can be purchased
from Brocade. Refer to part number CAB-CX4-0050 when ordering.
NOTE
The CX4 transceiver is not hot-swappable.
1
48
to"Cleaning the fiber-optic connectors"
toTable 2 on page 50.
on page 48.
Brocade FastIron Edge X-Series Hardware Installation Guide
Part Number: 53-1002499-02